SIX INCH Z RAIL RISER KIT NOW AVAILABLE!

SIX INCH Z BACKING PLATE AND ACME SCREW EXTENSION
SIX INCH RISER KIT INSTALLED ONTO 510 TABLE

SIX INCH KIT INSTALLED ONTO 510 TABLE

My long awaited SIX INCH Rail Riser Kit is now available! (Limited stock on hand.) This kit will raise the rails of the PlasmaCAM DHC2 (4×4) and the Samson 510 (5×10) tables 4.25 inches, to give your table fully SIX INCHES of Z clearance when combined with the PlasmaCAM (CSU) Customizable Size Upgrade for your DesignEdge license.*

This opens up a lot of possibilities! For example, this will allow you to lay a 6″ square or rectangular tube onto the grates and cut key slots along one side.

With a little “Redneck Engineering” and some out-of-the-box thinking, it also opens up the possibility of cutting PIPE up to 6″ in diameter WITHOUT the costly PlasmaCAM pipe cutting attachment or the software upgrade!

The kit is available in limited quantities for both the 4×4 DHC2 tables ($1,000.00) or the Samson 510 tables ($1,200.00). It will also work on the older 4×4 DHC tables, giving you 5-1/2″ of Z clearance. Each kit has all of the hardware necessary for BOLT-ON installation. NO DRILLING IS REQUIRED! This kit WILL NOT VOID your PlasmaCam warranty!

The kit includes a new extended length ACME screw for the Z motor, and an extended dust cover. It also has an extended length backing plate.

The corner brackets retain the original factory positions for the rails, and the 510 kit has extension blocks that raise the center joint of the two rails to the new height.

Several of these kits have been installed already, and the owners LOVE them!

  • The (CSU) Customizable Size Upgrade to DesignEdge software is REQUIRED in order for your table to make full use of the six inch Z configuration. This upgrade can ONLY be purchased directly from PlasmaCAM for $998.00

To purchase this kit for YOUR table, contact me at sixinchz@mail.com or visit my ETSY Store to purchase the kit directly.

https://www.etsy.com/HeyINeedThat/listing/1236676328/six-inch-rail-riser-kit-for-plasmacam?utm_source=Copy&utm_medium=ListingManager&utm_campaign=Share&utm_term=so.lmsm&share_time=1655148252677